Publicité
Important safety instructions--------------------------------------------EN
In compliance with the European Low Voltage Directive, we inform you of the following requirements:
•Disconnect the power supply before handing the receiver.
•When the devices remain permanently connected, an easily accessible connecting device must be incorporated into
the wiring.
•This system must only be installed by qualified professionals that have with automated garage doors and knowledge of
the relevant European standards.
•The user instructions for this device must always be in the user's possession.
•The operating frequency of the receiver does not interfere in any way with the 868 MHz remote control systems.
Use of the receiver
These receivers are designed for use as remote controls for garage doors.
Their use is not guaranteed for directly activating any other equipment different to that specified.
The manufacturer reserves the right to modify equipment specifications without prior notice.
2
Channel 1 operation led
3
Channel 2 operation led
4
Programming pushbutton
5
Jumper reset
7
BUS-L (+, -, L)
8
Memory card connection
9
Power supply
10
Relay 1 output
jcmtechnologies
2
Publicité
