Publicité
ANNEX
Troubleshooting / Problem solving
PROBLEM
CAUSE
The equipment does
A. The equipment is not plugged in.
not switch on
B. The safety strap is not in place.
The tape skates
The tape is loose.
Treadmill
oscillates
A. Not sufficiently lubricated.
when stepped on
B. It is too tight.
Tape is not centred
The tension of the treadmill is
incorrectly set on the rear wheel.
Display shows: E00
The safety sensor is not in place.
or E07
Display shows: E01
A communication problem has been
or E13
detected between the drive disk and
the console.
Display shows: E02 or
A problem has been detected in the
E06 or E10
disk drive/engine.
The display shows:
A problem has been detected with
E03
the speed sensor.
The display shows:
Tilted belt, motor problem detected.
E04
The display shows:
The electrical protection has tripped.
E05
The display shows:
A problem has been detected in the
E08
control unit.
The display shows:
A
E09
detected.
The display shows:
The power supply protection has
E11 or E14
tripped.
The
equipment
is
The surface is not flat.
unstable
stability
problem
has
SOLUTION
A. Connect the unit to the mains.
B. Place the safety strap in the correct location.
Adjust the belt tension.
A. Lubricate the running board.
B. Adjust the belt tension
Adjust the belt alignment.
Position the safety sensor in the correct place on the console.
Check the connections between the console and the disk drive. If
the connectors or wiring are damaged, replace them.
Check that the mains supply is according to specifications. Check
the drive unit and motor connections, if damaged, replace them.
Check all connections, if the motor or control unit is damaged,
replace it.
Check all connections, if the motor or control unit is damaged,
replace it.
Check that the mains power supply is in accordance with the
specifications. Make sure the treadmill is not snagged or unable to
rotate because of an obstruction. Check all connections. Check
the motor or control for short-circuit faults (usually indicated by a
burning smell) and replace parts as necessary.
Check all connections, if the control unit is damaged, replace it.
been
Ensure that the machine is properly unfolded and placed on a
flat and level surface. Check all connections, if the control unit is
damaged, replace it.
Ensure that the machine is properly unfolded and placed on a
flat and level surface. Check all connections, if the control unit is
damaged, replace it.
Place the machine on a flat surface. If applicable, rotate the legs
underneath the front of the machine to move it up or down as
necessary to make the equipment stable.
18
EN - MC-70
Publicité
