Publicité
28
Set-up / Foot Massage
1. Place the main unit (1) on the floor.
2. Connect the barrel connector of the mains adapter (2) to the socket for mains adapt
er (10) on the main unit.
3. Plug the mains adapter into a plug socket.
4. Adopt a comfortable seated position in a chair or on a sofa and place your feet
barefoot and without exerting pressure on the massage areas (9). You must be bare
foot for the device to work.
5. Control the device by pressing the buttons on the main unit or the remote control (4)
(see the "Operating the Device").
Massage With EMS Pads
The EMS pads (6)
section).
1. Clean and dry your calves.
2. Connect two EMS pads to the poles of the electrode cable (5). Both electrodes
must be used for the device to work.
3. Plug the connector of the electrode cable into the socket (11) on the main unit (1).
4. Repeat that with the other EMS pad pair if you wish to use them all.
5. Peel the protective films off the EMS pads and stick them onto the area being treated.
Stick one EMS pad onto the beginning of the muscle and the other onto the end of the
muscle. Do not overlap the EMS pads! Keep the protective films!
6. Control the device by pressing the buttons on the main unit or the remote control (4)
(see the "Operating the Device").
Operating the Device
Control the device by repeatedly pressing the buttons on the main unit (1) or on the
remote control (4). The activated functions and levels are shown on the display (8).
1. Switch on the device. To do this, press the button
display will light up.
2. Select a massage mode by repeatedly pressing the button
are 25 modes (see below).
3. To start stimulation of your feet press the button + (24) or press the button + (19) if
you are using the EMS pads.
4. Press repeatedly the button + to increase the intensity to the level where stimulation
still feels pleasant. Use the button – (20 or 23) to reduce the intensity if necessary.
L
After each change of mode, the intensity is automatically set to level 0 and
needs to be increased.
5. To switch off the device, hold down the button
L
The device switches off automatically after 25 minutes.
*
The electrode pads have passed the biocompatibility test. The test report shows that they do
not cause skin irritation.
03211_de-en-fr-nl_GM_A5_V4.indb 28
03211_de-en-fr-nl_GM_A5_V4.indb 28
are used to treat the calves (see the "EMS Pads Usage Examples"
*
(18) for about 2 seconds. The
(21) or
for approximately 2 seconds.
(22). There
19.04.2024 09:31:19
19.04.2024 09:31:19
Publicité
