Publicité
20 | English
User interface (see figure D)
The user interface (11) is used to select the working mode
and to indicate the status of the power tool.
Status indicator
Meaning
(16)
–
Power tool switched off
Green
Power tool switched on and ready to use
Yellow
Warning message
Red
Error message
Blue (flashing)
Data transfer
Indicator: Jaw Cleaning/Checking Reminder
– If the reminder (15) or (14) lights up, you must check the
jaws (23).
– If required, clean the jaws (see "Clean the jaws (see
figures E1−E3)", page 22).
– Only reset the reminder once you have checked the jaws.
To do so, press and hold the RESET (19) button for
2 seconds.
Selecting the working mode
The AUTO (18) button can be used to choose between two
working modes.
– AUTO ON working mode:
To set a blind rivet, press the on/off switch (12) briefly
and then release it again. The riveting process is automat-
ically completed.
Advantage: Convenient riveting
– AUTO OFF working mode:
To set a blind rivet, press and hold the on/off switch (12)
until the blind rivet is fully set and the rivet mandrel has
broken off. Then release the on/off switch in order to
complete the riveting process
Advantage: Quick riveting (depending on the blind rivet/
nosepiece combination that is used)
Working Advice
The power tool with built-in Bluetooth
u
Module is equipped with a radio interface. Local oper-
ating restrictions, e.g. in aircraft or hospitals, must be
observed.
In areas in which the Bluetooth® wireless technology
u
must not be used, the Bluetooth® Low Energy Module
must be switched off via the app.
LED worklight
The LED worklight (13) improves visibility in the immediate
work area. It is automatically switched on when the on/off
switch (12) is pressed.
Suspension device
You can use the hanging ring (3) to attach the power tool to a
suspension device (e.g. on a production line).
– To do so, fold the hanging ring (3) upwards.
1 609 92A 7R1 | (22.06.2022)
Regularly check the condition of the hanging ring and
u
the catch in the suspension device.
Belt clip
You can use the belt clip (7) to conveniently secure the
power tool to your belt.
Connectivity functions
System Requirements for Using the App
System Requirements
Mobile device (tablet,
smartphone)
Installing and Setting up the App
You will need to install the device-specific app before you
can use the connectivity functions.
– Download the app from the corresponding app store
(Apple App Store, Google Play Store).
Note: You will need to have a user account with the relev-
ant app store to do this.
App name
Bosch Toolbox
– Then select the MyTools or Connectivity sub-item in the
app.
– The display of your mobile device shows you all of the
subsequent steps required to connect the power tool to
the mobile device.
Data Transfer via Bluetooth
The built-in Bluetooth
regular intervals. Depending on ambient conditions, multiple
transmission intervals may be required before the power
®
Low Energy
tool is detected. If the power tool is not detected, check the
following:
– Is the distance to the mobile device too great?
Reduce the distance between the mobile device and the
power tool.
– Is the coin cell for the built-in Bluetooth
ule weak or drained?
Contact an authorised after-sales service centre for
Bosch power tools to replace the coin cell.
– Switch Bluetooth
Check whether the power tool has now been detected.
Functions in Conjunction with the Power Tool
In conjunction with the Bluetooth
following connectivity functions are available for the power
tool:
– Registration and personalisation
Android 6.0 (and newer)
iOS 11 (and newer)
iOS
Android
®
®
Low Energy Module sends a signal at
®
Low Energy Mod-
®
off and on again on your mobile device.
®
Low Energy module , the
Bosch Power Tools
Publicité
