Publicité
Belt sander and drum sander safety warnings
▶
Hold the power tool by insulated gripping surfaces, because the sanding surface may contact its own cord. Cutting a "live" wire may
make exposed metal parts of the power tool "live" and could give the operator an electric shock.
Additional safety instructions
▶
Use the power tool only when it is in perfect working order.
▶
Never tamper with or modify the power tool in any way.
▶
The power tool is not intended for use by persons who have received no special training. Keep the power tool out of reach of children.
▶
Always hold the power tool firmly with both hands on the grips provided. Keep the grips dry, clean and free from oil and grease.
▶
After installing the backing pad, always install the screw cap.
▶
Check the power tool, the backing pad, the supply cord and the connections at regular intervals for wear.
▶
Check the power tool's supply cord at regular intervals and have it replaced by a qualified specialist if found to be damaged.
▶
Check extension cords at regular intervals and replace them if found to be damaged. Do not touch the supply cord or extension cord if it is
damaged while working. Unplug the supply cord from the power outlet.
▶
In the event of an interruption in the electricity supply, switch the power tool off and unplug it from the power outlet to prevent an unwanted
restart when power is restored.
Description
1
Product overview
Sanding head
@
Extractor
;
Gripping surfaces
=
Control panel
%
Power cord socket
&
Hose connector
(
Intended use
The product is a hand-held, electrically powered random orbital sander. It is suitable for dry-sanding wood, wood-based materials, composites,
varnishes, paints, plastics, plaster and filler compounds with wearing, replaceable sanding pads.
Possible misuse
•
This product is not suitable for working on hazardous materials.
•
This product is not suitable for working in a damp environment and use of the product for wet sanding is prohibited.
•
Do not use backing pads with a nominal working speed lower than 8000 rpm.
LED indicators on the control panel
On the control panel there is a multi-purpose LED to indicate operating status or malfunction of the power tool, and an LED array for indicating
speed (rpm).
Status
A: Multi-purpose LED shows green
B: Multi-purpose LED shows green
C: Multi-purpose LED flashes green/red
D: Multi-purpose LED shows red
D: Multi-purpose LED quick-flashes green/red
3
Sanding head
The sanding head is 180° flexible, enabling the operator to reach the surface to be sanded from different angles. The power tool can track the
operator's movements, so the operator can adopt an ergonomic working position.
Items supplied
Random orbital sander, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at: www.hilti.group
Technical data
For rated voltage, rated current, frequency and/or input power, refer to the country-specific type identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be at least twice the rated input power
shown on the rating plate of the device. The operating voltage of the transformer or generator must always be within +5 % and -15 % of the
rated voltage of the device.
Weight in accordance with EPTA procedure 01
Speed
*2301586*
2
2301586
Backing pad
)
Multi-purpose LED
+
On/off button
§
Speed indicator
/
Increase/reduce speed
:
Start/stop button
∙
Meaning
AC supply connected.
Power tool switched on and/or start/stop button pressed, speed
indicator active.
Speed is increased/reduced; selected speed is indicated by the
LEDs.
Overtemperature warning.
Voltage outside appropriate range.
DWS 225
3.5 kg
4,000 /min ... 8,000 /min
10
Publicité
