Publicité
SELECT PRETARE
1. Press G/ N key to ensure scale is in net mode.
Ptl 0
2. Press PT key. "
key to select desired stored item (0-9). Press ZERO
key to display pretare value.
CLEAR PRETARE VALUE
1. Press PT. Display will show "
2. Use M+ and PT buttons to select pretare item (0-9).
3. Press ZERO key to display pretare weight.
4. Press and hold PT for three seconds and follow steps
to set pretare value to zero.
THERMAL PRINTER
NOTE: Thermal printer is located at the bottom
of the control panel. Reorder Uline model #
S-16160.
1. Open the paper roll cover by pulling down the
cover. (See Figure 15)
Figure 15
2. Insert paper roll. Feed the paper roll end through the
cover. (See Figure 16)
Figure 16
3. Close the cover tightly.
4. Press the M+/ Print key to print.
PAGE 8 OF 35
OPERATION CONTINUED
" is shown on display. Press TARE
Ptl 0
".
Paper Roll Cover
Paper
PRINTOUT FORMATS
PARAMETERS
Format 1
Format 3
The scale has parameters that can be set by the user.
1. To set parameters, press the ZERO key and TARE key
at the same time.
2. The display will show the first function, "
3. Pressing the TARE key will cycle through the other
functions.
4. Pressing ZERO key will allow you to set the function.
5. It may be necessary to either use TARE key set a value
or use the M+ and PT keys to move the active digit and
then using the TARE key to increment a digit, followed
by the ZERO key to enter the value.
6. Use the U key to leave a parameter unchanged.
7. For example when the display shows "
the ZERO key to begin.
8. The display will show "
set the weighing unit to ON/OFF status.
9. Press ZERO key to enter value, and the scale will
show the next weighing unit. Use TARE key to set and
ZERO key to enter. When finished, press U key to exit.
Format 2
F1 unit
F1 unit
on lb
". Press the TARE key to
0924 IH-4564
".
", press
Publicité
