Publicité
HANDLE INSTALLATION
1. Remove handle from protective wrapping.
2. Loosen set screw on crank link. (See Figure 7)
Crank Link
Set Screw
Figure 7
3. Remove three hex screws and three spring washers
from bottom of handle.
4. Feed wire, chain and pin on bottom of handle
through center of base and axle. (See Figure 8)
Wire
Pin
PAGE 5 OF 35
ASSEMBLY CONTINUED
Figure 8
Chain
Base
Axle
5. Attach handle to base using three hex screws and
three spring washers and tighten with hex wrench
provided. (See Figure 9)
Figure 9
6. While raising crank link, slide pin of rod and chain
into crank link groove. (See Figure 10)
Figure 10
Hex Screw
Spring
Washer
Base
Crank Link
Pin
0924 IH-4564
Publicité
