Publicité
Remove control panel from packing foam. (See Figure 1)
Figure 1
ATTACH CONTROL PANEL
1. Feed excess cable into the control panel head.
Align three holes in control panel with three holes on
pallet truck base. (See Figure 2)
Figure 2
2. Remove the two screws (one on each side) to release
the front panel. Carefully open the front panel.
(See Figure 3)
Figure 3
PAGE 4 OF 35
ASSEMBLY
3. Align mounting holes on pallet truck with mounting
holes on control panel. (See Figure 4)
Figure 4
4. Insert and tighten three hex screws with spring
washers through base of control panel with hex
wrench provided. (See Figure 5)
Figure 5
Screw
Washer
5. Close front panel and secure with two screws.
(See Figure 6)
Figure 6
Hex
0924 IH-4564
Publicité
