Publicité
Step 3: Align handset ( H ) along the front edge of
Step 4: Attach control box ( F ) to tabletop using 2 x screws ( C ).
The ideal location for the control box is to the immediate left
or right of the center leg, with the AC cable port pointed to
the back edge.
TIP: Y ou can place the control box anywhere on the tabletop.
Where you place the control box may depend on where you want
the AC cable ( G ) to hang down from the tabletop, or if there are
other items being attached to the tabletop that may interfere with
the control box.
10
upCentric
– UPMOD-3L Owner's Manual | Guide de l'utilisateur
®
the tabletop, 1"- 3" from the desired corner,
and attach handset to the tabletop with
2 x screws ( D ).
Step 5: Attach All cables to the control box:
• Plug the AC cable ( G ) into the port marked AC
• Plug the wires from the legs ( K ) into the ports
marked M1 and M2
• Plug the wire from the handset ( H ) into the port marked H
Step 6: Bundle all loose cables together and zip tie together using
zip ties ( L ). Attach zip ties ( L ) to tabletop using screws ( C ).
Step 7: Attach feet ( J ) to legs ( K ) using bolts ( A ).
Step 8: Prepare table for use:
• Flip table over into the upright position and plug the AC cable
into a wall outlet.
• Make sure the legs are correctly synchronized by performing
a re-sync – see instructions on page 12.
• If needed, adjust glides so that table is level and sturdy.
upCentric
– UPMOD-3L Owner's Manual | Guide de l'utilisateur
®
11
Publicité
