Publicité
Gyro-sensor anti-collision system
Every upCentric
electric height adjustable table has a built in gyro-sensor
®
based anti-collision system. This patented anti-collision system uses precision
gyroscope technology, allowing for three axis collision detection.
This sensor provides enhanced safety to help prevent user injury and
equipment damage. When the table is in motion, if it encounters any
external resistance or unbalance in the tabletop, the gyro-sensor picks up
the disturbance immediately and enacts a safety stop. The table will stop
moving immediately and reverse adjustment by 1" to move away from the
obstruction is has come in contact with.
Power-saving and quick start wake-up
upCentric electric height adjustable tables have the lowest power draw of
any electric height adjustable table on the market. When no buttons have
been pressed for 30 seconds, the control box goes into stand-by mode,
where the control box uses less than 0.1 W of electricity.
When in sleep mode, press any button to wake the system up. The quick
start feature allows the table to start moving immediately once a button
has been pressed, with no wake-up delay.
Parallel connectivity
The UPMOD - 3L upCentric is equipped with parallel connectivity.
This feature allows you to connect two tables together and operate them as
one table. A Y-splitter cable is required to enable this.
4
upCentric
– UPMOD-3L Owner's Manual | Guide de l'utilisateur
®
Important information
• Always make sure all screws are tightened before
use of the table and after moving or transporting.
• D uty cycle of the frame for desk is 10 %,
max. 2 minutes operating / min. 18 minutes stop.
• E nsure the loading on each leg is less than the maximum
outlined below, otherwise it might cause permanent damage
to the leg (s) during operation.
Table maximum
Each leg maximum
• W hen the motor cable is connected to the control box, the legs
can maintain an adequate locking force up to the maximum load on
the tabletop. However, when the cable is damaged or is disconnected
from the control box, it will cause the desk to sink to the bottom within
hours if the load on either leg is larger than the maximum capacity.
• M ake sure that no persons or items will collide with the table,
when adjusting upwards and downwards.
•
Damaged cords must be replaced before connecting
the main power cable.
• Keep at least 3/4" of free space around the whole frame / tabletop.
•
The upCentric
is not intended to be used as a person lift.
®
•
Do not pull or push the table if adjusting.
• Do not lift the frame or table off of the ground when adjusting.
upCentric
– UPMOD-3L Owner's Manual | Guide de l'utilisateur
®
Load capacity
400 lbs ( 180 kg )
175 lbs ( 80 kg )
5
Publicité
