Publicité
Installation Steps
1
Press tab
to detach
Detach front module from
back plate by pressing
the tab (located at the top
and bottom of the control
casing).
5
Leave operating instructions with home owner.
Icons
OPERATION
INDICATORS
SECTION
AUTOMATIC
SECTION
AUTOMATIC MODE
SELECTION
(ECO MODE)
OPTIONS &
PREFERENCES
SECTION
Troubleshooting
If error code 05 is displayed on the touchscreen control, double check the "A" and "B" signal wire.
Ensure the DIP switches are in the bottom "OFF" position.
NOTE: Balancing steps shown in ventilator installation instructions (included with compatible ventilator models).
2
Routing the
wires
Guide the signal wires (4)
through the central opening
of the back plate and mount
this plate to either a standard
electrical device box or directly
to the wall using screws. If
required, use wall anchors.
NOTE: Be sure the screws are
secure but do not over tighten.
This may result in damage to
the back plate.
MANUAL
VENTILATION
MODE SELECTION
MANUAL FAN
SPEED SELECTION
MANUAL SECTION
MAX MODE
SELECTION
(20 40 60 MINUTES
TIMER OVERRIDE)
OPTIONS & PREFERENCES
SELECTION
3
Terminal
block
3.0mm small/
flat head
screwdriver
Insert the wires (4) into the
terminal block, located on
the backside of the front
module. Secure them in
place by tightening the
terminal screws using a
small 3.0 mm slot/flat head
screwdriver (not included).
NOTE: For each wire, take
note of the wire color
chosen and connect to the
corresponding terminals for
the control and the HRV /
ERV. See illustration below.
B
A
D+
Control
Ventilator
OPERATION INDICATORS
Air Exchange
Recirculation
Mode Animation
Mode Animation
Fan Speed Level
Fan Operation
and Timer
Animation
Attach front module to
mounted back plate,first
by hooking the top of the
front module to the top clips
of the back plate, then by
pressing the bottom of the
front module until you hear
a 'click'.
Ensure the ventilation
system operates correctly.
NOTE: Be careful not to
pinch or trap the wires when
attaching the front module
to the back plate.
S+
S
B
A
T+
T-
W
W
D-
D+
M39472
System Stand-by
Icon Activation
M39482
4
M39481
Publicité
