Publicité
UK: INSTRUCTION MANUAL
IF YOU WISH TO FINALLY DISPOSE OF THE DEVICE
1. Remove cables, lid, tie-down brackets from body with compressor and dispose according to
local regulations. Ask your local recycling centre for details about how to do this in accordance
with the applicable disposal regulations.
2. Place the packaging material in the appropriate recycling waste bins wherever possible.
2. PRODUCT FEATURES
• High-efficiency DC compressor and conversion module.
• CFC free and great heat insulation.
• DC 12/24V
• Fast cooling to -20°C/-4°F(based on 25°C/77°F room temperature).
• Intelligent battery protection system.
• Digital display for temperature setting.
• Wireless charging and USB port.
3. PRODUCT STRUCTURE
4. INSTALLATION
1. Remove the original vehicle console.
2. Install the included mounting bracket and tighten the screws.
3. Install the console fridge using the cigarette lighter.
4. Connect the included DC power cable to the vehicle's cigarette lighter.
4
5. FUNCTIONS AND OPERATION
Set
Power
Temperature
Control
USB: 5V/1A
• Power Supply: connect to DC 12V/24V
• Display Screen Initialization: connect to the power supply, the buzzer will make a long beep and the
display will be on for 2 seconds then enter the normal operating mode.
• Power On/Off: press
to switch ON/OFF.
• Temperature Setting: press
or
for temperature setting, the setting will be saved automatically after
having stopping operating for three seconds (Note: the temperature displayed is the current temperature
of the compartment, it wiII take a while to reach the set temperature.)
Temperature setting range: -20~20°C (-4~68°F).
• Cooling Mode: under the running state, press
Mode). (*Factory setting is MAX).
• Battery Protection Mode: under the running state, long press
then press
again to select protection mode H (High), M (Medium) and L (Low). (*Factory setting is H).
VOLTAGE REFERENCE:
INPUT
DC 12V
MODE
CUT-OFF
L
8.5V
10.1V
M
11.1V
H
* the voltage is a theoretical value, there may be a deviation in different scenarios.
* H should be set when the product is connected to car power, and M or L should be set when it is
connected to a portable battery or other back-up battery.
• Temperature Unit Setting: switch off the cool box, long press
switch to E5 by pressing
again. Under E5 mode, press
setting is °C.)
• Reset: switch off the cool box, long press
for three seconds until E1 displays, under E1 mode, long
press
at the same time for three seconds to reset it.
• Wireless charging: Place your mobile phone in the centre of the wireless charging section to start
charging. Note: Your mobile phone must support wireless charging.
UK: INSTRUCTION MANUAL
(-20) Current Temperature
(°C °F) Temperature Unit
(H.M.L) Battery Protection Mode
(13.5v) Current Voltage
MAX (Fast cooling)
ECO (Energy-saving)
Current Battery (for reference)
to switch to MAX (fast cooling) and ECO (Energy saving
for three seconds until screen flashes,
DC 24V
CUT-IN
CUT-OFF
CUT-IN
10.9V
21.3V
22.7V
11.4V
22.3V
23.7V
12.4V
24.3V
25.7V
for three seconds until E1 displays, then
or
to select Celsius or Fahrenheit. (*Factory
5
Publicité
