Publicité
Serial No.
LED
★★
1
★—5 sec
1
★★★
1
★—5 sec
1
★★★★
1
★★★★★
1
V Cutting procedure
1. Prepare the hydraulic cutter: Position the cutter so it is ready to cut.
2. Insert the cable: Place the cable into the incision point of the electric cutter.
3. Automatic spring-back: Once the cable is cut, the cutter will automatically spring back to its original position.
EN
Sound
Instructions
Power on self-check
Overload
●●●
Charging prompt
● – 5 sec
Power shortage alarm
●●●●
Temperature alarm
●●●●●
No pressure
Meaning
System
is
normal;
completed
Hydraulic system may malfunction;
requires immediate check
Low battery level; tool can be used
a
few
more
times;
recommended
Battery
depleted;
immediately
Battery over temperature limit;
charge needed immediately
Motor running without pressure
self-check
charge
charge
Publicité
