Publicité
EN
Replacing the saw blade:
Be careful to turn off the switch and unplug the power plug before installing or disassembling the wheel
disc. To disassemble the blade (5), press the shaft lock rod forcefully first so that the blade cannot rotate.
Loosen the hexagon bolts (14) counterclockwise using spanner (18). Remove hex bolts (17), washers (16)
and (15) and blade (5).
Install the blade (5) according to the reverse procedure of dismantling the wheel blade. When installing
the blade, make sure that the direction indicated by the arrow on the blade surface is the same as the
direction indicated by the arrow on the wheel cover. The hexagonal bolt (17) must be tightened firmly.
Mounting and adjusting the parallel fence:
The parallel fence (12) is used for cutting parallel to the edge of the workpiece.
Mounting
1. Slacken the locking screw (3) as to allow the parallel fence to pass.
2. Insert the parallel fence (12) in the base plate (6) as shown.
3. Tighten the locking screw (3).
Adjusting
1. Slacken the locking screw (3) and set the parallel fence (12) to the desired width.
2. Tighten the locking screw (3).
Instructions for use
1. Always observe the safety instructions and applicable regulations.
2. Ensure the material to be sawn is firmly secured in place.
3. Apply only a gentle pressure to the tool and do not exert side pressure on the saw blade.
4. Avoid overloading.
5. Do not use excessively worn saw blades.
6. Do not use your saw for pocket cuts.
Prior to operation:
1. Make sure the guards have been mounted correctly. The saw blade guard must be in closed position.
Publicité
