Publicité
USER MAINTENANCE
Cleaning and user maintenance shall not be made by
children without supervision.
The internal mechanism of your clipper has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company or an Andis
authorized service station.
If the supply cord is damaged it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into Andis
Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES
Blades should be oiled before, during, and after each use. If your clipper blades leave
streaks or slow down, it's a sure sign blades need oil. Hold the clipper with the blades
pointing down to prevent oil from getting into the motor. Place a few drops of Andis
Clipper Oil on the front and side of the cutter blades (Figure D). Wipe excess oil off
blades with a soft dry cloth. Spray lubricants contain insufficient oil for good
lubrication, but are an excellent clipper blade coolant. Always replace broken or
nicked blades to prevent injury. You can clean the excess hair from your blades by
using a small brush or worn out toothbrush. To clean the blades we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus, while the
clipper is running. Any excess hair and dirt that has accumulated between the blades
should come out. After cleaning, turn your clipper off and dry blades with a soft, dry
cloth and start clipping again.
REPLACEMENT (REMOVAL) OF BLADE SET
To remove the blades, first unplug the clipper from the electrical outlet. Turn the
clipper upside down, so that the blade teeth are pointing down. You may want to
place the clipper on a flat surface to do this. Unscrew the screws on the blade (Figure
E). Remove the blades. To replace the blades, put the smaller upper blade back into
position (Figure F). Line up the screw holes in the bottom blade with the two holes in
the clipper housing, and replace screws. Do not tighten down screws completely.
Turn clipper over and align lower blade so teeth on both blades are parallel, but with
lower blade's teeth slightly above the upper blade teeth. Failure to do this may result
in nipping the skin when cutting the hair.
BLADE & CLIPPER/TRIMMER REPAIR SERVICE
When the blades of your Andis clipper become dull after repeated use, it is advised
to purchase a new set of blades available through your Andis supplier or through an
Andis authorized service station. If you have a problem contacting your Andis
supplier contact the Andis Company customer service department at
1-262-884-2600 or email at info@andisco.com.
6
Publicité
