Publicité
7. Place the transparent cover
top of the watertank
Installing the remote control
1. Flip the remote
and open the battery cover by
pressing and sliding it backwards.
2. Place the battery in the correct orientation.
TIP: When the buttons are facing down,
the '+'-side of the battery should face up.
3. Slide the battery cover back in place until you
hear an audible 'click'.
NOTE:
•
Only use 1x CR2032 battery.
•
Safely dispose empty batteries.
•
Remove the battery if the remote control is to
be stored unused for a long period of time.
and lid
back on
.
Filling the water tank
WARNING: Only fill with cold or lukewarm water.
Hot or boiling water will damage the device.
1. Unplug the power cord and take off the lid
2. Fill the water tank
can or container .
WARNING: Do not exceed the "MAX" level
on the transparent cover.
3. Place back the lid
properly.
4. Plug the device back in the power outlet.
5. You may now turn on the device.
NOTE: Always unplug the power cord when filling the
water tank.
NOTE: When using the device for the first time, the
water may have a slight smell and discoloration. This
is normal and not harmful for your health.
.
with water using a watering
and make sure it fits
7
Publicité
