Publicité
GB
CONT.
securely, taking care to avoid creases or folds, after securing the zip flap additional tape should also be applied to allow for full
type protection. When using this unhooded coverall with a separate hood, ensure the hood has an elasticated facial opening and a
shoulder coverage of 10 cm that should be worn under the garment. The hood should be fully taped to the coverall.
• No garment provides complete protection against all chemicals or hazardous agents. The determination of suitability of Ansell
products, whether alone or in combination with additional PPE for an application is the final responsibility of the user.
• Models with attached socks; the socks are designed to be worn inside chemical protective boots (sold separately) with the over flap
positioned over the top of the boot opening. Attached socks or boots are unsuitable for walking or standing in chemical spills or
pools of liquids.
• Slip retardant footwear offers limited resistance to slip, but will not eliminate completely the risk of slipping and/or falling, especially
on wet surfaces. Ensure that socks or boots provide adequate mechanical resistance for the surface to be walked upon and that the
sole is not damaged. Some materials used in over boots, overshoes or attached socks or boots are not for use in environments where
there is a risk of slipping and/or falling.
• Models featuring silver retro-reflective tape for enhanced visibility; the product does not conform to EN ISO 20471.
• Models featuring finger loops; should only be used with a double glove system where the wearer puts the finger loop over the under-
glove and the second glove is then worn over the garment sleeve.
• Warning - if present, hook and loop fasteners shall not be opened when operating in hazard zones
• Partial body protective clothing does not meet the full body coverage requirement of EN 1149-5: 2008. A full risk assessment, which
considers the use of additional full body protective clothing that conforms to EN 1149-5:2008, should be carried out to ensure that
the garment(s) can be adequately grounded and the actual body coverage achieved is acceptable.
In the unlikely event of defects, do not wear the garment. Return the defective garment (unused and uncontaminated) to your
distributor.
Storage:
Do not store in excess heat or direct sunlight
Disposal:
Dispose of garments according to local regulations
For questions please contact the Ansell technical team.
The manufacturer disclaims all warranties not specifically stated in the product packaging and is not responsible for the improper use
of Ansell products.
AlphaTec
2300 STANDARD
®
INSTRUCTIONS FOR USE
3
Publicité
