AKO 16526A V2 Guide Rapide page 22

Step 5:
Select the temperature set point.
Step 6:
Set all other parameters to default?
dFP=0
No, the other parameters do not need to be changed.
dFP=1 Yes, set all other parameters to their default values.
This option only appears if this is not the first time the set-up wizard has been run.
The initial configuration is now complete, and the device will start to regulate the temperature.
The configuration wizard will not reactivate. To reactivate it, activate the stand-by mode (by pressing the
m key for 3 seconds) and wait until the unit completely halts regulation (the m indicator will light up
permanently) and press the , , SET buttons in this order in sequence, not at the same time.
If the Pump Down function is active, there may be a delay between the initiation of the Stand-by function
and the moment the controller stops.
Registration on akonet.cloud (only AKO-16526AN)
In order for the controller to be able to send operation data to akonet.cloud, it must be registered.
To do this, go to https://akonet.cloud
one of these two methods:
• Enter the serial number (S/N) and validation code / IMEI that appear on the tag and press "Search".
• Capture the QR code that appears on the tag using the
tablet or mobile phone).
These data are found on the tag on the right hand side of the controller. More information can be found in the
akonet.cloud user guide at: "https://enhelpakonet.ako.com/"
To access akonet.cloud, enter this address in your browser (the use of Google Chrome is recommended): https://
akonet.cloud.
Before activating the device, make sure that there is enough reception at the installation location.
Activated devices may not be returned.
Forcing transmission
When the steps of the configuration wizard and the registration process are completed in akonet.cloud, you must
force a first transmission to verify the level of reception:
Press and hold the ESC and SET keys for 3 seconds.
After a moment, the display shows the quality of the NBIoT signal received:
Low quality
The controller does not start transmitting data to akonet.cloud until the first transmission
is forced.
(requires registration), click on "Add new device"
Medium quality
22
1652H6A41 Ed. 04
5
option (requires having a camera on your PC,
Communication
High quality
 /  / SET
and continue with
error