Publicité
help of the stand.
2. Remove the engine oil dipstick 1.
3. Place a drain pan below the engine. Dismantle the
drain plug 2 and its washer to drain the original
engine oil.
4. After draining all the engine oil, install the drain plug
2 and its washer.
5. Fill 800 milliliter of new engine oil into the engine via
the oil filling port of the dipstick.
6. Install engine oil the dipstick again 1.
7. Start the engine and have it run for several minutes.
8. Stop the engine and inspect the engine oil with
the dipstick several minutes later.
level should be between the UPPER LEVEL and the
LOWER LEVEL.
BCAUTION
Use
the
engine
oil
"Instructions for use of fuel and engine oil".
BCAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
Haojue UH115/UH115S 99011H57012H000 V03 (HJ110-7C) 2019-9-12
The engine oil
recommended
in
the
Haojue UH115/UH115S 99011H57012H000 V03 (HJ110-7C) 2019-9-12
Engine oil strainer
BWARNING
Due to that the cover of the right crankcase must be
removed before removing the strainer, whether the
strainer needs to be replaced should be determined
by the professional technical personnel of the
dealer.
CLUTCH
Adjust the clutch by the following
steps:
1. Unscrew the clutch locking nut
1.
2. First,
clockwise revolve the
clutch adjusting screw 2 for
one loop, and pay attention not
to revolve too much.
3. Then, anticlockwise revolve the clutch adjusting screw
2 until feeling a slight resistance.
4. From this position revolve the clutch adjusting screw
2 for a 1/8–1/12 loop (20–30 degrees), and then
screw up the locking nut 1.
5. After the adjustments, start up the engine while
checking whether any skids occur in the clutch and
the gear positions can be smoothly alternated.
35
(37)
EN
(37)
Publicité
