Publicité
(14)
Haojue UH115/UH115S 99011H57012H000 V03 (HJ110-7C) 2019-9-12
"&" position
All lights mentioned above will be turned off.
ELECTRIC STARTUP BUTTON 2 #
This button is used for operating the starter motor. With
the ignition switch at the "*" position and the transmission
in neutral, grasp the brake lever and push the electric
starter button # to operate the starter motor to start the
engine.
BWARNING
EN
Engaging the starter motor for five seconds at
a time can damage the start motor and wiring
harness from overheating.
Do not engage the starter motor for more than five
seconds at a time. If the engine does not start after
several attempts, check the fuel supply and ignition
system.
Refer to the "TROUBLESHOOTING"
section in this manual.
BWARNING
When cleaning the motorcycle, do not directly
clean its electric parts, particularly its handle
switch.
BWARNING
Do not use the electric start function and the kick
lever function at the same time.
(14)
Haojue UH115/UH115S 99011H57012H000 V03 (HJ110-7C) 2019-9-12
BWARNING
Do not start the motorcycle when the fuel or engine
oil is insufficient.
THROTTLE GRIP 3
The engine speed is controlled by the position of the
throttle grip. Turn it toward you to increase engine speed.
Turn it away from you to decrease engine speed.
FRONT BRAKE LEVER 4
The front brake is applied by grasping the brake lever
gently toward the throttle grip. The brake light will be alight
when the brake lever is grasped inward.
CHOKE LEVER
(A)
To make starting convenient, the motorcycle is provided
with a choke. During a cold engine start, pull the choke
lever to the position (A) and open throttle grip slightly to
start the engine. After the engine is started, pull back
the choke lever by half to position (B) and open throttle
grip slightly to make the engine continually preheat until it
reaches the required temperature. Finally, pull the choke
lever back to its original position (C). During a hot engine
12
(B)
(C)
Publicité
