Publicité
ATTACHING TO A SIMULATION RIG
You can use the included bolts to attach to a plate
on most simulation rigs Similar to the desk clamp,
attachment to the bottom or the back of the RS
Shifter & Handbrake body is possible
Depending on the thickness of the plate you are
attaching to, washers (not included) may be needed
to ensure the bolts don't encroach too far within the
casing of your product Follow this guideline to ensure
you do not damage your product
Where T = the thickness of the plate that you're
attaching the shifter to and 20mm is the maximum
that a bolt can be allowed to encroach inside the
product
20MM
T
L
For example, if you have a 4mm thick plate then
the bolt can not be any more than 24mm in length
(4mm + 20mm = 24mm) If using longer bolts,
washers of appropriate size will need to be used
BOLT BOLT
L = T + 20MM
in order to reduce how far the bolt encroaches inside
the product
Note: for attaching more than one RS Shifter &
Handbrake to your rig, the desk clamp can also be
used to accommodate different configurations
6 ENGLISH
Publicité
