Publicité
Installation
2. INSTALLATION OF THE HOOD INTO A WALL CABINET USING A HORIZONTAL
DIVIDER FOR SUPPORT.
Follow the steps below:
1 - Check the measurements indicated in Fig.s 1 and 2 and the minimum distance
from the cooktop, before installing the hood on the support shelf.
2 - Install a support shelf a the width of the cabinet interior at (9" from the bottom)
(1/2" thick).
3 - Make sure the thickness of the wall cabinet is within the parameters indicated
in Fig. 4 - step 2.
4 - Install the hood in the wall cabinet and make sure the 2 side springs F are
connected correctly. Fasten the hood to the wall cabinet using the screwdriver
and the relative screws M and tighten until the device is firmly against the wall
cabinet (Fig. 4 - step 2).
5 - Fasten the hood to the upper support shelf as indicated in Fig. 5 - step 6. - Once
you have fastened the hood to the wall cabinet, adjust the spacer L, with screws P,
to fill the gap between the hood and rear wall. (Fig. 4 - step 5).
IMPORTANT - The range hood must be secured to wall studs or using
drywall anchors capable of supporting 75 lbs.
- 17 -
Publicité
