Getting Started - Explore Scientific WSH4005 Mode D'emploi

GETTING STARTED

INSERT BATTERIES
1.Remove the battery door from the back.
2.Insert 3x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries match
upon installation.
3.Reattach the battery door.
NOTE: Replace batteries when [
display is dim.
OUTDOOR SENSOR
The main unit can receive data from up to 3 outdoor
sensors. 3 sensors are included with delivery.
1.Remove the battery door from the back.
2.Select a channel.
3.Insert 2x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries match
upon installation.
4.Reattach the battery door.
5.Place the sensor within 30 m (98 ft) of the main
unit using the table stand or wall mount.
TO SEARCH FOR A SENSOR:
The main unit will automatically search for a new
sensor after the batteries are installed. The receiving
process is 3 minutes. During receiving process, the
antenna icon [ ] is flashing. Once receive signal,
monitor will receive the outdoor temperature and
humidity at the same time.
Press and hold [ CH ] to re-register RF data.
If RF registration failed or missed for more than 1
hour, the data will flash "--.-".
To manually initiate an outdoor sensor search,
press and hold [ CH ].
NOTE: The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC
reception is initiated. To manually start RCC
reception, press and hold the [ DOWN ] button.
2. After the RCC receives the signal, if you change
the relevant display settings (such as year,
month, day, hour, minute, etc.), the RCC symbol
[
3. If the RCC receiving process is successful, a
completed RCC symbol [
the display and the date and time will be set
automatically. If it fails, press and hold the [ DOWN ]
] when the
button to re-initiate RCC receiving.
4. RCC receiving will automatically start from 1:00
– 5:00 every night. Auto receiving function will
cease if it is successful. If it does not receive
the RCC signal, it will receive in next day.
5. If the device is still not receiving the signal,
please proceed to set the time manually.
SET THE CLOCK MANUALLY
1. Press and hold [ SET ] button to enter into time
and date setting.
2. The setting parameter will flash.
3. Press [ UP ] button once, the figure will increase
1 unit. Press and hold the [ UP ] button, the
figures will increase rapidly.
4. Press [ DOWN ] button once, the figure will
decrease 1 unit. Press and hold the [ DOWN ]
button, the figures will decrease rapidly.
5. Press [ SET ] button to confirm setting and enter
to next parameter.
6. Sequence of setting: Time Zone
Minute
12/24HR
7. If there is no action in 20 seconds or if you
press [ SET ] button, the setting will be saved
and you will exit the setting mode.
°C/°F SETTING
Press [ UP ] button to switch Celsius (°C) /
Fahrenheit (°F).
ALARM
SETTING/ADJUSTING ALARM TIME
1. Press [ SET ] to display the alarm time.
2. Press and hold [ SET ] button to enter alarm
setting mode.
3. The setting parameter will flash.
4. Press [ UP ] or [ DOWN ] button to set the
desired data.
5. Sequence of setting: Hour
6. Press [ SET ] button to confirm setting and exit.
7. Alarm will turn on automatically when alarm
setting is finished. Alarm time is 2 minutes.
] will automatically disappear.
Year Month
Exit
EN
IT
DE
] will be shown in
FR
ES
NL
Hour
Day
Minute Exit.
5