Getting Started - Explore Scientific WSH4003 Mode D'emploi

GETTING STARTED

INSERT BATTERIES
1.Remove the battery door from the back.
2.Insert 3x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries match
upon installation.
3.Reattach the battery door.
NOTE: Replace batteries when [
display is dim.
OUTDOOR SENSOR
The main unit can receive data from up to 3 outdoor
sensors. 3 sensor are included with delivery.
1.Remove the battery door from the back.
2.Select a channel.
3.Insert 2x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries match
upon installation.
4.Reattach the battery door.
5.Place the sensor within 30 m (98 ft) of the main
unit using the table stand or wall mount.
TO SEARCH FOR A SENSOR:
The main unit will automatically search for a new
sensor after the batteries are installed. To
manually initiate an outdoor sensor search, press
and hold [ CH ].
NOTE: The transmission range may vary depending
on many factors. You may need to experiment
with various locations to get the best results.
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC
reception is initiated. To manually start RCC
reception, press and hold the [ DOWN ] button.
2. After the RCC receives the signal, if you
change the relevant display settings (such as
year, month, day, hour, minute, etc.), the RCC
symbol [ ] will automatically disappear.
3. If the RCC receiving process is successful, a
completed RCC symbol [
the display and the date and time will be set
automatically. If it fails, press and hold the
[ DOWN ] button to re-initiate RCC receiving.
4. RCC receiving will automatically start from
5. If the device is still not receiving the signal,
SET THE CLOCK MANUALLY
] when the
1. Press and hold [ MODE ] button to enter into
2. The setting parameter will flash.
3. Press [ UP ] button once, the figure will
4. Press [ DOWN ] button once, the figure will
5. Press [ MODE ] button to confirm setting
6. Sequence of setting: 12/24HR
NOTE: Week language setting order: EN
7. If there is no action in 20 seconds or if you
°C/°F SETTING
Press [ DOWN ] button to switch Celsius (°C) /
Fahrenheit (°F).
] will be shown in
1:00 – 5:00 every night. Auto receiving function
will cease if it is successful. If it does not
receive the RCC signal, it will receive in next
day.
please proceed to set the time manually.
time and date setting.
increase 1 unit. Press and hold the [ UP ] button,
the figures will increase rapidly.
decrease 1 unit. Press and hold the [ DOWN ]
button, the figures will decrease rapidly.
and enter to next parameter.
Hour Minute
Day
Week language
FR IT DU
press [ MODE ] button, the setting will be saved
and you will exit the setting mode.
Time Zone
Year Month
Exit
GE
SP DA
EN
IT
DE
FR
ES
NL
5