Publicité
Location
- Place your freezer away from sources of heat (heating, cooking, sunlight, etc). For your freezer to
work properly, the ambient temperature of the room must be between +16°C and +3 2°C (class N).
Outside these limits, the freezer will not function normally.
- Make sure there is a good circulation of air behind the freezer; do not place it flat against a wall in
order to prevent vibration noise. Make sure that air is circulating free ly all round the freezer.
Insufficient ventilation will stop your freezer working properly and increase energy consumption.
- This freezer should be installed so the plug remains accessible. Make sure after installing it
that it is not resting on the power cable.
- Level the freezer using the 2 adjustable feet.
- The freezer is delivered with 2 plastic spacers so it can
be positioned at the necessary distance from a wall.
This will allow optimal performance of your product.
Place the spacers in the holes at the back at the top
and turn them 45° to the right or left.
There must be a 20mm gap between the side of the freezer and the adjacent cabinet.
Connection to power supply
Your freezer is designed to operate at a single phase voltage of 230 vo lts.
It must be connected to a wall socket that is earthed and protected by a 16 A fuse.
Safety information relating to freezers
If you use this freezer in accordance with the instructions, it will operate correctly.
- Only use the freezer to store froze n food products, freeze fresh food products and make ice.
- Do not consume ice cubes or ice lollies straight after taking them out of the freezer because they
may cause cold burns.
- Do not store full bottles of liquid in the freezer because they might explode .
Getting your freezer ready
Once the appliance is properly installed, we advise you to clean the inside with slightly soapy warm
water (washing-up detergent). Do not use abrasive products or scouring powder which might damage
the finish.
Control panel
(position 2)
j Green light : lit when appliance is working.
k Red light: lit when temperature of freezer is not low enough.
l Yellow light: lit when rapid freeze function is on.
m Rapid freeze button
n Thermostat
The red indicator light will illuminate when the appliance is first plug into the mains supply and will
remain on until the correct operating temperature as been reached.
INSTALLATION
USING YOUR FREEZER
35
Publicité
