Publicité
07.4 Attaching the pan to the desired location
☛
NOTE:
»
This product can be installed with either a horizontal or vertical outlet For a horizontal
outlet, use a flexible straight pan connector, which is not included For a vertical outlet,
use a flexible 90° angled pan connector, also not included
1
Mark Floor: Test fit the toilet assembly to the pre-installed pan connector and use a
pencil to mark the floor at the locations of the mounting holes
Place the Sound Insulation Mat: Place the sound insulation mat (2) along the
2
marked line
22
3
Draw a Straight Line: Using a pencil and a measuring tape, connect the two marks
from the previous step with a straight line
4
Mark Drill Points: Measure 6 9 cm (±1 cm) towards the center from the two marked
points and mark the two drill points with a pencil
5
Safety Precautions: Ensure no pipes or power lines are beneath the surface Use a pipe
and cable locator to eliminate any potential risks before drilling
6
Drill Holes: Drill two 45 mm holes at the marked drill points
7
Insert Floor Plugs: Insert the floor plugs (3) into the drilled holes
| EN |
Publicité
