Publicité
07 INSTALLATION
07.1 Installing the fill valve to the cistern
1
Preparation: Begin by removing the hex nut (35) and plastic washer (36) from the pipe
thread (34)
2
Insert Pipe Thread: Position the pipe thread (34) into the appropriate top hole of the
cistern, according to where the water inlet is located Attach the plastic washer (36),
ensuring the fill valve is vertical, and secure the connection by tightening the hex nut
(35)
20
Seal Extra Holes: Use the side cap (21) and counter bracket (22) to plug any unused top
3
holes in the cistern
07.2 Installing the flush valve to the cistern
1
Base Bracket Setup: Unfasten the locknut (50) by turning it counter-clockwise and
remove the rubber washer (49) Hold the base bracket (47) and rotate it in the same
direction to unlock it
| EN |
90°
Publicité
