Vortice MICROSOL V0 Notice D'emploi Et D'entretien page 11

- Unit is equipped with manual reset thermal breaker device: in order
to avoid any danger of accidental reset of the thermal breaker device,
units must not be powered by an external switch device such as a
timer, or must not be connected to a circuit that is regularly powered
or disconnected from power utilities.
4 Safety/Warnings
o
OBLIGATION
- After removing the appliance from its packaging, ensure that it is complete and undamaged. If in
doubt contact an authorised VORTICE service centre. Do not leave packaging within the reach of
children or differently able persons.
- Store the appliance out of the reach of children and disabled persons if you decide to disconnect it
from the power supply and use it no more.
e
- For full compliance with European Regulation No. 2015/1188 EU, this product must be subjected to
an external control device that regulates heat emission in the room where it is installed.
OBLIGATION
- In the event that the appliance malfunctions or develops a fault, contact VORTICE immediately.
Ensure that only genuine original VORTICE spares are used for repairs.
- Regularly inspect the appliance for visible defects. If they are found, do not operate the appliance
and contact VORTICE immediately.
- Check that the electrical power supply/socket provides the maximum electrical power required
by the appliance. If this is not the case, arrange for a qualified electrician to make the necessary
modifications.
- In the event that the appliance is dropped or suffers a heavy blow, have it checked immediately by
VORTICE.
- If the appliance is to be used in a bathroom, it must be installed where its switches and controls are
inaccessible to persons in the bath or under the shower (Fig. 3).
- Make sure that the door protecting the controls is closed properly after making any adjustments.
- The appliance must be properly connected to an electrical system in compliance with applicable
i
regulations, and must be equipped with an efficient earthing system. If in doubt, have a qualified
electrician perform a thorough check.
p
OBLIGATION
Specifications for the power supply must correspond to the electrical data on the plate A (Fig. A).
OBLIGATION
Switch off the system main switch when:
– if the appliance does not function correctly;
– before cleaning the outside of the appliance;
– the appliance will not be used for a short or long period of time.
ENGLISH
11