Guardian Envoy 380 Mode D'emploi Et Garantie page 2

WARNING!
FAIluRe to FolloW these INstRuctIoNs mAy Result IN INjuRy.
• Do not use your walker until the handles are properly adjusted and securely tightened.
• Press folding mechanism past center line for full engagement prior to use.
• Do not use this walker on hills. A wheeled walker may not provide adequate support on slopes.
• Do not exceed the maximum weight capacity listed on the walker.
AssemBly:
INstAll hANDle BARs
1. Loosen the adjustment knobs.
2. Insert the handle into walker frame (Figure 1).
3. Stand inside the walker and move the handle up or down until it is in line with the bend in your wrist.
4. Tighten knobs securely.
INstAll BAsKet (Sold Seperately)
1. Attach basket to the frame by placing the basket hooks toward the back inside walker frame (Figure 2).
2. Pull the basket towards the front of the walker until the hooks engage around the body frame
and the basket rests on the folding mechanism.
usING youR WAlKeR
FolDING youR WAlKeR
1. Push down on the center folding mechanism bar until the bar is past center line and fully
engaged (Figure 3).
2. To unfold, place all wheels on the ground. With one hand, pull-up on the center folding
mechanism bar.
locKING AND uNlocKING youR WAlKeR's BRAKes
1. To lock brakes, push down on brake loop handle until it "clicks" into the locked position
(Figure 4).
2. To unlock, pull up on brake loop handle.
(Figure 1)
(Figure 3)
1
(Figure 2)
(Figure 4)
GS-G07981T (GPI171)
Revised: 2/22/10