Format A New Memory Card; Power-Save Mode - Philips Digital Pocket Memo LFH 9600 Manuel De L'utilisateur

To insert a memory card:
Locate the memory card slot on the top back side of the Digital
1
Pocket Memo (17).
Slide the memory card into the slot. A small illustration under
2
the memory card slot indicates the correct orientation.
Push the memory card in until you hear a click.
3
D Note: If the Digital Pocket Memo is turned to the
and there is no memory card inserted, a warning screen is
displayed.
The memory card that is packaged with the Digital Pocket Memo is
already formatted and ready for use. If a memory card is inserted
that is not formatted, the Digital Pocket Memo will offer the option
to format it. Refer to the next chapter for more information.
3.5

Format a new memory card

When a new, unformatted memory card (or a memory card that was
formatted with a non-Digital Pocket Memo device) is inserted, the
Digital Pocket Memo will display a prompt to format the memory
card. To confirm and start the formatting process, press the
smart button (2a). To cancel the formatting process, remove the
memory card or press the CANCEL
The Digital Pocket Memo will be unable to make any recordings
without a properly formatted memory card. If a new card was
inserted and the formatting process was cancelled, insert another
card that can be formatted or has already been formatted.
Important: Formatting is not possible if the memory card is in
C
read-only mode (locked).
3.6

Power-save mode

When the Digital Pocket Memo is left inactive for more than four
minutes, it automatically goes into power-save mode and the LCD
screen will display the date and time. The Digital Pocket Memo can
be reactivated by pressing any button or moving the 4-position slide
switch. This does not initiate the function of the corresponding
button, except when the 4-position slide switch is moved to the
PLAY position; this will start playback.
D Note: If voice-activated recording is enabled and the Digital
Pocket Memo is in recording mode, the device will go into
power-save mode after 60 minutes.
If the Digital Pocket Memo is not used for more than two hours,
it turns off completely. In this case, turn the unit on by moving the
On/Off switch (13) to the OFF
position, or alternatively by moving the 4-position slide switch.

2
1
ON
smart button (2b).
position and then back to the
position
OK
ON
User manual