EN
PRODUCT DESCRIPTION
1 Controls
2 Upper glass
3 Point laser
4 Bumper
5 Anti-fall sensors
6 Charging contacts
7 Centre wheel
1
2
3
4
1
1 Filter cover
2 Container release button
3 Side sensor
2
Docking station
1 Station body
2 Bottom cover
3 Charging indicator light
4 Signal transmission location
1
5 Station contacts
6 Cable slot
2
7 Connector
76
8 Side brushes
9 Battery cover
10 Running wheel left and right
11 Rotary brush cover
12 Rotary brush
13 On/Off switch
5
6
7
8
9
10
12
13
11
3
6
3
7
4
5
List of parts
1 Rotary brush
2 Rotary brush cover
3 Remote control
4 HEPA + foam filter for 2in1 container
5 HEPA + foam filter for dust container
6 Cleaning cloth
7 Side brushes pair
2
1
3
4
6
7
KEY FEATURES
Cleaning / ON/OFF
• Press briefly to start or pause cleaning.
• Press and hold for 3 seconds to switch the appliance
on or off.
• Long press for 15 seconds to force the appliance to
shut down under unusual circumstances.
Charging / Local cleaning
• Press briefly to start or pause charging.
• Long press to start local cleaning.
Indicator light
• Blue: Normal operation or charging
• Red: Abnormal condition or low battery
Wi-Fi reset
• Press both buttons simultaneously for 3 seconds.
INSTALLATION
1. Connect the power cord.
Note:
• Provide a space of at least 0.5 m on either side of
the docking station and at least 1.5 m in front of the
station.
• If the power cord is stretched vertically to the ground,
8 Cleaning brush
9 Wiping module
10 2in1 dust container + water tank
11 Dust container
12 Docking station
13 Adapter
8
10
5
11
9
12
13
the appliance may pull it out and the docking station
may be switched off.
• The charging light is always on when the docking
station is connected to the power supply.
2. Do not move the docking station or expose it to
direct sunlight.
Note: Direct sunlight will interfere with the docking
station signal and the appliance may not return to the
docking station properly.
3. Installing the side brushes
Make sure the left side brush (L) and right side brush
(R) markings correspond to the L and R markings on
the bottom cover. Push the side brushes L and R until
you hear a "click" sound.
4. Putting the appliance into operation and charging
To switch the robot on, press and hold the button
If the power indicator light is normally on, charge the
robot in the docking station.
Note: If the appliance does not start due to a low
battery, charge it in the docking station and it will start
automatically. Normally, the appliance can only operate
when the battery level is ≥15 %.
EN
.
77