Publicité
b) While cutting, do not disassemble the guards to ensure safety and stability.
c) Never touch the diamond wheel during operation.
d) Do not force the tool. It will work efficiently and safely within its designed limits.
e) If the diamond wheel stops or makes abnormal noises during operation, immediately turn
off the switch.
f) Disconnect the tool before servicing or changing accessories like blades, bits, or cutters.
During reuse
a) Inspect for damage before reuse. Check guards and other parts to ensure they function
properly. Look for misalignment, binding, breakage, and any conditions that could affect
performance. Damaged parts should be repaired or replaced.
b) Use the tool at the correct input level as specified on the nameplate. Operating above the
specified input may reduce accuracy and cause motor overload, leading to reduced
efficiency.
c) Consult an authorized service agent if the tool malfunctions.
3. Maintenance
1) Inspecting the diamond wheel: A dull diamond wheel can cause motor damage and reduce
efficiency. Replace the wheel immediately if you notice signs of wear or abrasion.
2) Inspecting the mounting screws: Regularly check all mounting screws to ensure they are
properly tightened. If any screws are loose, retighten them immediately. Failure to do so
could result in a serious hazard.
3) Maintaining the motor: The motor winding is a crucial part of the tool. Inspect it carefully to
ensure it is not damaged or exposed to oil or water. Clean the entire tool regularly to
maintain optimal performance.
4. Application
Suitable for cutting various types of stones and tiles used in decoration.
•
The blade can tilt to any angle between 0° and 45°.
•
The angle ruler on the table can be adjusted to any angle between 0° and 90°.
•
During cutting, the pump supplies water to the blade, which extends the blade's life and
•
reduces dust.
To cut, place the material on the table. Adjust the parallel guide so it is perpendicular to the
•
cutting track of the saw blade, then tighten the screw at the end. Secure the ruler in the
appropriate position.
The user can replace components, such as the blade or rubber tube, by themselves.
•
EN
Publicité
