Publicité
•
Keep the area well lit.
•
Do not use tools near flammable liquids or gases.
e) Prevent electric shock by avoiding contact with grounded surfaces such as pipes or radiators.
f) Use the right tool. Do not force small tools to do the job of a heavy-duty tool. Only use the
tool for its intended purpose.
g) Use only a diamond wheel for cutting. Do not use any other cutting tool.
h) Ensure the switch is in the "OFF" position before plugging in the power cord.
Inspect the diamond wheel before use. Check for cracks, broken parts, or bends. Do not use
i)
the wheel if any defects are found. Run a test to confirm it works properly.
j)
Maintain tools carefully. Keep them sharp and clean for optimal safety and performance.
Follow instructions for lubricating and changing accessories.
k) Use an earth leakage circuit breaker or an isolating transformer to prevent electric shock.
l)
Do not use the tool for cutting materials it is not designed for, or for curved cutting. This can
damage the diamond wheel or significantly shorten its lifespan.
m) Do not clean plastic parts with solvents. Solvents like gasoline, thinner, or oils containing
chlorine can damage and crack plastic parts. Clean with a soft cloth lightly dampened with
soapy water.
n) Personal protective equipment must be worn:
•
eyes, so always wear eye protection.
•
your nose and mouth.
•
noise. To protect your ears and concentration, wear ear protection.
•
operation freehand.
•
the cutting line. The blade is sharp and can cause serious injury.
•
reduces dust and chipping. Always remember to use water while cutting.
o) Place the workpiece on a portable table and rest it securely against the slide rack before
cutting.
p) Use clamps or a vise to hold the workpiece. This is safer than using your hands and frees
both hands to operate the tools.
During operation
a) Switch on the machine and wait for it to reach full speed before starting the cutting
operation.
Wear eye protection. Cutting can produce chippings that may injure your
Wear a respirator. Cutting generates dust, so wear a respirator to protect
Wear ear protection. The machine is powerful and cutting may generate
Wear gloves. Always wear gloves during operation. Do not perform any
Keep hands away from the blade. While cutting, keep your hands clear of
Use water cooling. Water cooling improves cutting performance and greatly
EN
Publicité
