Publicité
PRODUCT OVERVIEW
The cordless grease gun is used to apply solid greases. The grease gun has its own grease tank and a fl exible hose with a tip
adapted to typical grease nipples (so-called grease fi ttings). Thanks to the battery power supply, it is possible to apply the grease
quickly, easily and effi ciently even in places without access to power sources. Proper, reliable and safe operation of the product
depends on appropriate use, that is why you should:
Read this entire manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool, failure to observe the safety
regulations and recommendations of this manual. Use of the tool for purposes other than those for which it was intended shall
cause the loss of the user's rights to a warranty and under statutory warranty.
PRODUCT ACCESSORIES
The YT-07020 tool is supplied with a battery and a battery charging station. The YT-07021 tool is supplied without battery and
without a charging station.
TECHNICAL DATA
Parameter
Catalogue No.
Operating voltage
Grease capacity
Grease pressure
Hose length
Noise level
- sound pressure L
± K
pA
- power L
± K
wA
Protection rating
Insulation class
Vibration level (with / without impact)
Weight
Battery type
Battery capacity*
Charger*
Input voltage
Mains frequency
Rated power
Output voltage
Output current
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared total vibration emission value and declared noise emission value have been measured using the standard test
method and can be used to compare one tool to another. The declared total vibration emission value and declared noise emission
can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an assessment of emission exposure under actual condi-
tions of use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time),
must be specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
O R I G I N A L
EN
Unit
[V DC]
[g/min]
[MPa]
[cm]
[dB(A)]
[dB(A)]
[m/s
2
]
[kg]
[Ah]
[VAC]
[Hz]
[W]
[V DC]
[A]
[h]
I N S T R U C T I O N S
Value
YT-07021, YT-07021
18
284
62
76
76.0 ± 3.0
86.0 ± 3.0
IPX0
III
0.5 ± 1.5
3.45
Li-Ion
3
220 - 240
50 / 60
60
21 DC
2.4
1
11
Publicité
