Publicité
TROUBLESHOOTING
Incorrect operations are often misteken for trouble and malfunctions. If you think that there is something wrong with this component, check
the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being
used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your
dealer to carry out repair work.
immediately.
Pauses or Stops during playback.
Symptom
Cause
Disc tray is not expelled wnen OPEN/ | @
Power plug is disconnected from outlet.
CLOSE is pressed.
When
playback is started, it stops | e
Disc is loaded upside down.
|
@
Smudges, etc., on the disc.
Connect plug to amplifier or wail outlet
@
load the disc correctly with the Jabel side
DOWN
@® Clean the smudges from the disc and then play
it again.
No sound
Sound is distorted, noise is output.
With certain discs, loud noise is
produced, or play stops.
Remote control will not function.
The picture of the TV screen
is
fluctuating or FM broadcast has noise
interference.
Output cords are connected incorrectly or
loosely.
@
Incorrect operation of stereo amplifier
@
The OUTPUT button is set incorrectly.
Pin plugs and/or amplifier terminals are dirty
®@ Player is in pause mode.
|
@
Connect properly.
Check the settings of amplifier switches and
sound volume controls.
@
Set the OUTPUT
button according
to the
conneciion,
@
Clean away dirt.
@
Press the ® button,
ae |
@ Incorrect connections.
|
@
Pin plugs and/or amplifier terminals are dirty.
|
@
Interference is being picked up from a TV
set.
@
Disc has bad scratch or warp.
@
Disc is extremely dirty.
@
Dead batteries.
@
Too far irom player or wrong angle.
@
Obstruction
between
player and remote
control unit.
@
Interference is being picked up from the
CD player.
®
Connect to amplifier's AUX or CD terminals.
Do not connect to PHONO terminals.
@
Clean away dirt.
@
Switch OFF TV set, or move player away from
TV set.
@
Replace the disc.
@
Clean di
@
Replace batteries
@
The distance between remote control unit and
player should be no more than about 7 meters.
The operational angle against the front pariel is
within 30° from right or left end of player.
e@ Relocate
remote
control
unit or remove
obstruction.
@
Turn off POWER
of the player, or move the
player away from TV or tuner.
«
A humming sound is heard when a
tape is played with the cassette deck
set on top of the CD player.
System
remote
control
does
not
function correctly.
ette deck away from the CD player
@ The ground lead unit is disconnected .(PD-S95)|
e@ Only the digital output cable Is connected.
{except for PD-S95}
Connect the ground lead unit
Connect the output cable for analog audio
Abnormal functioning of this unit may be caused by lightning, static
electricity, or other external interference. To restore normal operation,
turn the power offand then on again, or unplug the AC power cord and
then plug it in again.
27
<PREI165>
En
Publicité
