Publicité
PLUNGE CUTTING
WARNING: To avoid loss of control, damage to the blade or damage to the workpiece, always use extreme
caution when making plunge cuts. It is not recommended to plunge cut any material other than wood.
1. To plunge cut inside the edges of a workpiece, clearly mark the cutting line on the workpiece.
2. Set the depth and set the bevel angle at 0°.
3. Set the saw on the workpiece so the front edge of the sole plate (1) is flat on the workpiece.
4. Open the blade guard by rotating the blade guard lever (2) forward.
5. Align the saw blade with the cutting line (3) using the 0° cutting mark on the sole plate.
NOTE: Make sure the saw blade is inside the area to be cut out.
6. Start the saw and slowly lower the blade onto the workpiece while holding the blade guard lever
forward to allow the blade to cut into the workpiece.
7. Continue lowering the blade into the workpiece until the full cutting depth has been achieved.
Continue sawing and complete the cut as required.
EN
Publicité
