Publicité
EN
b) When re-installing the outer flange nut make sure the flats of the flange nut fit over the flats on the
spindle.
c) Turn the blade screw counter clockwise to thread it into the spindle. Make sure the screw is not cross
threaded.
6. When the new blade, outer flange and blade screw are in place, press the spindle locking button and
fully tighten the blade screw.
7. When the blade screw is fully tightened, carefully rotate the blade to ensure it does not wobble. If it
wobbles, remove and reinstall the blade making sure it is installed correctly.
INSTALLING THE EDGE GUIDE
The edge guide can be used to facilitate accurate cutting when ripping pieces up to 5" wide.
1. Loosen the edge guide locking screw counter clockwise approximately 2 turns using the 5mm hex key
(Drawing B).
2. Slide the edge guide mounting rod into the mounting slots in the sole plate.
3. Align the desired cutting width on the scale with the 0° cutting mark in the sole plate.
4. Tighten the edge guide locking screw to lock the edge guide into position. Do not overtighten as you
may strip the threads.
5. Make a test cut on a scrap workpiece to verify the edge guide setting. Adjust as necessary.
3.4.
Device use
Switch On/Off
Before turning on / off the switch, check the saw blade for proper installation and smooth operation, bolt
tightening condition.
To start the machine, press the Lock-off button and press the trigger.
To stop the machine, release the trigger, and then the machine stops.
Depth adjustment
Before cutting, move the depth guide lever on the
depth guide bracket to the desired position and fix it.
Publicité
