Publicité
5
FINAL DRY FIT
5a. Once all the panels are dry fitted correctly in place
with no gaps, secure the bottom of each side panel
to the tub with tape.
5b. Remove the Rear Wall Panel and mark both Left and
Right Wall Panel locations, top and bottom, so when
the Side Panels are removed for the addition of
adhesive on the studs, the panels can be returned
back to the same locations.
5c. Unscrew and remove both Left and Right Side Panels.
6
APPLICATION OF ADHESIVE, SIDE PANELS
6a. Measure and draw a line 58" from deck of tub up
each 2x4 that will contact rear side of wall panel.
The line will provide a location where to apply
adhesive. Starting with either Left or Right Side
Panel, apply adhesive with at least 1/4" bead on the
outside edges of studs that will contact back side of
panel 58" for a tub.
6b. Install the Side Panel back into the previously
marked position from step 5, check for plumb
and screw panel back in place.
6c. Press on the outside surface of the panel in the
area where the adhesive is applied to ensure good
contact of the adhesive to the
inside of the Side Wall Panel. Install the opposite
Side Panel in the same manner.
MARK
SIDE WALL
LOCATIONS
5A
CONSTRUCTION
ADHESIVE BEAD
MINIMUM 1/4"
BEAD TO ASSURE
BONDING TO BOTH
SURFACES!
58" FOR TUB.
Publicité
