Publicité
User's manual | BANKER Safe
5. Instructions for use BL MODELS
Manager code: 01-123456
Master code: 12345678
Automatic 5-minute locking system after entering 4 consecutive wrong codes.
For your safety, we strongly recommend changing these codes (see points 5.3 and 5.4).
5.1. First use
This safe should not be welded or built into the wall. Follow the installation instructions to anchor it
to the floor. Install your safe in areas with low humidity.
1. Slide the black plastic cover on the bottom of the keypad and remove the battery connector.
Connect a 9V alkaline battery. Insert it into the compartment inside the keypad and close the
cover.
2. Open and close the case several times (section 5.2).
3. Change the original codes (section 5.3).
Perform all checks with the door open before proceeding to close the safe.
5.2. Opening and closing instructions
4. Insert the key.
5. To activate the keypad, press "Ok". Then, enter the manager code: 01-123456. The box will wait
5 minutes and the red LED will flash. The display will show "TIME DELAY" + the minutes/seconds
remaining to wait (5 minutes in total).
5.3. Change of opening manager code
All safes leave the factory with the same combinations. For your safety, do not forget to change
them.
1. Press and hold the number 0 until you hear a double beep, the red LED will light up permanently.
2. Enter the current code (if the factory code has not been changed, it is 01-123456).
3. The screen will display "ENTER NEW CODE" accompanied by a double beep.
4. Enter the new 6-digit code. You will hear a double beep.
5. Confirm the new 6-digit code. You will hear another double beep.
The code will have been set successfully.
EN
18
Publicité
