Publicité
User's manual | BANKER Safe
4. Instructions for use E MODELS
Factory default openings:
Manager code pulsar: 123456
User code pulsar: 108088
4.1. Code Switching
Press and hold #0 until a double beep is heard, the red LED will remain illuminated during the code
change sequence.
Enter the old code (double beep).
Enter the new 6-digit code (double beep).
Confirm the new 6-digit code (double beep).
If a double beep is heard, the code is valid.
If a long beep is heard, the code is incorrect.
ATTENTION! If you enter 4 incorrect codes, the safe will be locked for 5 minutes. While the safe is
locked, it will flash once every 10 seconds.
4.2. Verificación del funcionamiento del teclado
Press and hold the number 5 until you hear a double beep.
Enter the following sequence of numbers: 1234567890. Each key will emit a double beep. If the lock
does not recognize any key, it will emit a long beep and the function will be interrupted.
4.3. Delay time programming
Press and hold the number 9 until a double beep is heard.
Enter the Manager code (123456).
Enter the delay time (2 digits: from "00" to "99" minutes. Note: the value "00" disables the delay time)
and the opening window (2 digits: from "01" to "19" minutes. Note: the value "00" is not accepted).
Double beep.
Confirm the value of the delay time ("00" to "99") and the opening window ("01 to "19").
Double beep is correct, one long beep in case of error.
Noe:
- During the delay time the Manager can only increase the delay time value. Lower values will be
EN
16
Publicité
