Publicité
User's manual | BANKER Safe
3. Installation
To install the safe, you do not need any special tools. Simply remove the box from its packaging and
place it in the place where it will be used.
The box has a hole for anchoring to the ground. If you want to anchor the safe, you will need to use
the following materials:
•
Drill
•
Wrench or socket wrench
3.1. Cleaning
Before using the safe, it is advisable to clean the inside and outside of the product.
Use a soft cloth, warm water and a neutral detergent. Rinse the surface using clean water and dry
it, making sure it is completely dry.
Take special care with the keypad area, where the electronic circuits are housed, as they could be
damaged if exposed to excess moisture. Perform a similar cleaning regularly for optimal preservation
of the product.
These safes should not be built into the floor; for this purpose we recommend our wide range of
floor safes.
Do not use harsh, abrasive or soda-based chemicals. They may damage the surface and
exterior finish of the product.
The bolts of the safe have been greased for better use and longer life. Do not wipe off this grease,
it is necessary for the correct operation of the mechanical system.
3.2. Battery status and replacement
A series of acoustic and visual signals indicate that the batteries are low and need to be replaced.
Make sure you use only 1 9V alkaline battery. Place it in the correct position.
We recommend changing the battery once a year.
EN
15
Publicité
