Publicité
ADDITIONAL SAFETY INSTRUCTIONS
Please read these safety instructions before use and
keep them carefully.
! - This symbol indicates the risk of injury or damage
to the device.
! Failure to follow the instructions in this manual may
result in injury.
! The trowel planer complies with valid technical
regulations and standards.
! Always put on safety glasses or goggles with side
shields and a full face shield if necessary before using
the machine.
The operation of the machine can cause foreign
objects to be thrown towards the operator, which can
result in serious eye injuries.
! Before starting the machine, check that all fastening
screws are firmly tightened.
! Always turn off the engine and disconnect the
machine from the power source before making any
adjustments. energy.
! Always make sure all protective covers are in place
before operation.
! Do not force the machined product through the
machine. Allow the planer to automatically apply the
correct feed rate.
! Check the feed rollers occasionally to make sure
there are no sawdust or shavings between them.
If the rollers do not fit tightly, they will not hold the
workpiece firmly against the bed, allowing kickback
to occur.
! Use the machine only for working with wood. Work
only with sound construction lumber with no soft knots
and minimal hard knots.
! Never stand directly at the feed or feed of material.
Always stand sideways to the machine.
! Make sure that there are no nails, screws, stones or
other foreign objects on the piece of wood that could
damage the knives.
! Always make sure the knives are properly attached
before working.
! Be careful when handling the knives and the knife
head. The knives are sharp, you can cut yourself
easily.
! Wait for the blade head to reach full speed before
working.
- Use protective equipment against noise, dust and
vibrations !!!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION
Plate thickness planing is the machining of material
to the required thickness, creating a smooth surface
parallel to the opposite side of the plate.
The art of planing depends mainly on good judgment
of depth of cut in various situations. You must take
into account: width, hardness, moisture and flatness
of the board, orientation and structure of the fibers.
Experience will tell you how these factors can affect
the quality of work. Whenever you are working with
a new type of wood, or wood with unusual problems,
always make test cuts on the scrap material first
before working on the actual piece.
1. Upper bar
2. Main switch
3. Overload protection
4. Table extension
5. Hand crank for raising the knife head
6. Cut depth scale
7. Shifter
8. Material removal depth scale
9. Tool tray
10. Key
11. Depth stop
12. Gauge-flange
PICTOGRAMS
Pictograms listed on the product packaging:
a) Power values
b) Power input
c) Idle speed
d) Maximum planing width
e) Maximum cut per shot
USE AND OPERATION
ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under heavy
loads.
Any other additional requirements must be the subject
of an agreement between the manufacturer and the
customer.
Mounting the planer on a wooden base
You can carry the planer using the handles on the
frame. When carrying the planer, make sure the table
extensions are folded. If the planer is not mounted
on some sort of stand or table, it is assumed to be
mounted on two pieces of lumber. This ensures
its maximum stability. Choose 2 pieces of wood
according to the dimension in Fig. B and mount the
planer to the wood. B1 - Mounting hole, B2 - Hole on
the base plate of the planer, B3 - M8 screw
Use the 4 long screws provided to mount the base
plate of the wood planer.
Cylinder for machined product
A cylinder is mounted on top of the planer, which is
used for convenient handling of the workpiece during
multiple planing. The workpiece, which is located on
top of the machine, can be slightly pulled towards the
operator.
49
Publicité
