Publicité
Active Touch Controller cont.
RESETTING THE ACTIVE TOUCH DISPLAY HEIGHT
1. Press 1, 2, 1, 2. The text will begin blinking "SELECT", "HEIGHT".
2. Lift up or press down on the controller to scroll through the starting height
options.
3. Once the correct height has been chosen, pause for 2 seconds.
4. The light guide will fill. When all three bars are full, the starting height is
saved.
ADJUSTING THE HEIGHT DISPLAYED
1. It may be necessary to adjust the height displayed, which is set to the
default setting from the factory.
2. Press and hold the 1, 2 and
3. The display will flash "ADJUST HEIGHT", and then the current desk height
will flash on the display.
4. Lift up or press down on the controller to change the height displayed.
The new desk height will flash until the light guide fills. TIP: The desk
should not move during this step.
SWITCH DISPLAY FROM INCHES TO CENTIMETERS
Press and hold the 1 and
change the display from "INCH" to "CM". The new selection will flash until the
light guide fills.
ERROR CODES
In the event of a fault, the display may show an error code number and brief
description. Refer to the error code list and troubleshooting guide.
buttons simultaneously for four seconds.
buttons simultaneously for three seconds, to
Scan to visit steelcase.com/
migrationcollection/errorcodes
Publicité
