Publicité
Active Touch Controller cont.
STORE HEIGHT INTO MEMORY
To set into memory the desired height for either seated or standing work, use
the two memory position buttons.
• Lift up or press down on the controller to reach the desired desk height.
• Press and hold the memory position button, 1 or 2, for 1 second until the
number 1 or 2 flashes and the light guide fills.
• To save an additional height, repeat this sequence using the 1 or 2 button.
• To clear all stored memory positions, press and hold the 1 and 2 buttons
simultaneously, for 1 second, until the display flashes "PRESET CLEAR"
and the light guide fills.
SET CHANGE OF POSTURE TIMER
The desk is equipped with Active Motion, which delivers a subtle up/down
motion signaling when it is time to move. The timer is set in 15 minute
increments, from 15-90 minutes.
• Press and hold the
preferred time is shown. Release the
to save the selection.
• The
icon will appear in the bottom right of the height display to indicate
that a timer is active. TIP: To wake the controller from sleep mode to view
the icon, press any button on the controller.
Note: If you do not change postures within five (5) minutes of the Active
Motion reminder, the timer will reset to OFF. You will need to set the posture
reminder timer again.
PAIR THE APP TO THE DESK
• To download the free Steelcase Rise app, visit steelcase.com/rise. The app
is compatible with both iOS and Android devices and allows you to connect
to the desk via Bluetooth in order to track sitting and standing activity.
• In your phone settings, set Bluetooth to On.
• On the controller, press and hold the 2 and
for 2 seconds, until the desk identification number appears
(e.g.
ID DESK - 1234).
• In the app, select the identification number that matches the desk you are
pairing to. Your phone should read "Connected".
• The controller will display "
• To exit from the display, press any button on the controller.
• The
will appear in the upper right corner of the height display to indicate
the desk is paired. TIP: To wake the controller from sleep mode to view the
icon, press any button on the controller.
button for 1 second and cycle through until your
button to select. The light guide fills
PAIRED" when successful.
buttons simultaneously
Publicité
