Publicité
3.1.1. Soft reset
If the unit does not respond as expected, you can perform a soft reset. This resets all measured and calculated values in
the controller and restarts the unit. The customised settings are retained.
MODE
1. Put the unit in any mode.
2. Press and hold the [-] and [+] simultaneously until the first 2 and the last 2 LEDs start flashing.
3. Release the [-] and [+].
4. The orange, blue and green lights will illuminate successively, the unit will reset and reboot.
4. SETTINGS
4.1. SETTING FANSPEED
1. Select the mode that you want to adjust: Cooling /
2. The unit runs at comfort speed.
3. Hold down [Mode] and [-] simultaneously until the first 4 LED's are flashing.
4. Short press [-] or [+] to adjust the preset speed.
20%
25%
30%
35%
40%
45%
50%
55%
60%
Default factory setting of the fan speed is selected depending on the device's length in order to guarantee the sound levels..
5. After 30 seconds, the new settings are automatically saved and the device returns to the selected mode.
JAGA NV | BRIZA M - TPT | MANUAL | 14.10.2024 | V.1.07
MODE
±15 sec
Heating
15 sec
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
EN
65%
70%
75%
80%
85%
90%
95%
100%
67
Publicité
