Publicité
Snelheid 1
– Permanently off: All functions are disabled until the user switches on the unit via the control panel. Hold down [Mode]
MODE
until all LEDs are off.
10 sec
MODE
10 sec
3.1. NOTIFICATIONS
Blue LEDs are flashing: the water temperature for cooling is too high
Red LEDs are flashing: the water temperature for heating is too low
Control panel error codes
LED flashes rapidly in the color of the set mode.
MODE
MODE
MODE
MODE
The LEDs are blinking in a pattern and in the color that matches the selected mode
Only if the window contact is connecrted and switched on: The window contact is open.
MODE
MODE
MODE
3.1.1. Soft reset
If the unit does not respond as expected, you can perform a soft reset. This resets all measured and calculated values in
the controller and restarts the unit. The customised settings are retained.
MODE
1. Put the unit in any mode.
2. Press and hold the [-] and [+] simultaneously until the first 2 and the last 2 LEDs start flashing.
3. Release the [-] and [+].
4. The orange, blue and green lights will illuminate successively, the unit will reset and reboot.
JAGA NV | BRIZA XS - ACO | MANUAL | 14.10.2024 | V.2.05
Snelheid 2
MODE
MODE
Check the water temperature sensor
Check the room temperature sensor
MODE
MODE
MODE
MODE
±15 sec
Snelheid 3
MODE
MODE
MODE
MODE
MODE
EN
MODE
MODE
MODE
MODE
47
Publicité
