Publicité
1/ Turn off the power of your ceiling fan using the circuit breaker or switch.
2/ Wait at least 10 seconds then turn on the power again.
3/ Within 30 seconds of turning on the power, press and hold the POWER
button of the remote control for around 5 seconds.
The receiver beeps when the synchronization is complete. You will then be able to use your
remote control to control your ceiling fan.
Controlling several ceiling fans using a single remote control
When several ceiling fans are installed, they can be controlled by a single remote control.
Repeat the above procedure with all the other ceiling fans that you want to synchronize on
the same remote control.
Reverse mode
By default your ceiling fan rotates counterclockwise (summer mode).
This mode allows the room to be refreshed by sending the cold air down and hot air at the
top. The winter mode, meanwhile, will allow you to heat the room by sending hot air down
(the blades turn in the opposite direction, clockwise).
WARNING : Do not change the direction of rotation of the blades when the ceiling fan
is running. Wait until the ceiling fan is stopped and the blades are completely
stationary before to make the change.
To change the direction of rotation of the blades, use the switch in the rear compartment of
the remote control.
F forward = S = Summer = counterclockwise rotation
R reverse = W = Winter = clockwise rotation
Fixing the wall bracket of the remote control
Install the bracket supplied with the supplied screws and plugs so that you can store your
remote control.
24
Publicité
