Publicité
5. HEIGHT UNDER BLADES
The minimum recommended distance between the floor and the blades is 230 cm.
You can use a meter to check this height (level of your floor / lower limit of the blades).
If the distance between the floor and the blades is less than the minimum recommended
above or if the structure of your interior does not meet this minimum, check the length of the
tube of your ceiling fan, it is sometimes possible to shorten it by few centimeters. Do not
forget, however, that a distance of 25 cm between the blades and the ceiling, ideally more, is
needed to promote good air circulation and optimal brewing.
If, on the other hand, you need an extension down rod to lower the level of your ceiling fan
(high ceiling), please contact your retailer, there are extensions of 90 cm and 120 cm for all
the models.
6. UNPACKING CHECK
Before assembling your ceiling fan, remove all parts from the package and make sure that all
of the following components are present :
- Ceiling fan hanger bracket
- Down rods and hanger ball
- Canopy and coupling cover
- Motor
- Kit remote control/receiver
- 5 blades and supports
- LED light dome
7. FIXING THE CEILING FAN HANGER BRACKET
Secure the ceiling fan hanger bracket with appropriate screws and plugs to the structure of
your ceiling.
The plugs should be located in the ceiling concrete structure and not in hollow elements.
Make sure the fixing is very strong.
The fixing must be done safely in the STRUCTURE of the ceiling by a qualified person.
We decline all responsibility in the event of a fall of the ceiling fan.
20
Publicité
