Publicité
- Connect the neutral of the ceiling with the neutral of the hanger bracket in the connecting
terminal N.
4/ Grounding
- Connect the ground wire of the ceiling to that of the hanger bracket in the connecting
terminal E.
- Connect one of the two grounding connectors of the hanger bracket to that of the hanger
ball of down rod.
- Connect the other grounding connector of the hanger bracket to that of the ceiling fan.
Check that all electrical connections have been correctly made and that the receiver and the
wires are properly stored in the hanger bracket.
Mount the canopy on the hanger bracket, place it correctly by inserting the 2 screws of the
hanger bracket in the notches of the canopy, turn the canopy until the screws lock in the
notches and tighten the screws if necessary.
11. USING THE REMOTE CONTROL
Insert the supplied battery into your remote control.
Operation
Press the POWER button to turn your ceiling fan on or off.
Press the + button to increase the speed (6 speeds), the
corresponding LED of the selected speed lights on.
Press the - button to decrease the speed (6 speeds), the
corresponding LED of the selected speed lights on.
Press the LIGHT button to turn the light on or off.
Press the TIMER button to set the timer (automatic stop once the selected time has been
reached), the corresponding LEDs light on: 1 LED = 1 hour / 2 LED = 2 hours / 3 LED = 4
hours / 4 LED = 8 hours. To deactivate the timer, press until all LEDs light off.
Synchronizing the remote control and the receiver
By default, the remote control and the receiver are already synchronized together.
If the receiver is not connected to the remote control, please follow the steps below :
23
Publicité
