Publicité
the tube (be careful to not damage the wires passing inside) then put back the pin. Finally
tighten the 2 screws so that the tube is fixed.
9. HANGING THE CEILING FAN
Put the hanger ball into hanger bracket, turn the down rod, let the concave groove of hanger
ball into the lugs of hanger ball plate (in hanger bracket).
Be careful to not damage the electrical wires and not wedge them between the hanger
ball and hanger bracket. Make sure that the ceiling faN is securely locked. Concave
groove of hanger ball must be putted into the bracket lugs.
10. ELECTRICAL CONNECTIONS
WARNING : Before proceeding to the electrical connections, carefully read the safety
instructions in this manual. Before any electrical connections, switch off all power and
restart only when the installation is complete.
Slide the receiver into the hanger bracket.
Once the receiver is properly installed, proceed to the electrical connections below :
1/ Connections from ceiling fan to receiver
- Connect the connector of the ceiling fan (3 wires : pink/grey/red) to that of the receiver (TO
FAN WIRES - MOTOR).
- Connect the connector of the ceiling fan (2 wires : blue/red) to that of the receiver (TO FAN
WIRES - LIGHT). If your ceiling fan is not equipped with a light kit, ignore this last
connection, do not connect that connector to the receiver.
2/ Connections from receiver to hanger bracket
- Connect the connector of the hanger bracket (3 wires : brown or black/blue/yellow and
green) to that of the receiver (AC POWER INPUT).
3/ Connections from hanger bracket to AC power
By using the connecting terminals provided on the hanger bracket :
- Connect the phase of the ceiling with the phase of the hanger bracket in the connecting
terminal L.
22
Publicité
